Description
eDIN DEMULTIPLEXER, 16 CHANNEL
The Pathway eDIN De-multiplexer converts DMX512 signals to 0-10VDC, or other common DC ranges, or to current-sinking control of Mark 7-type fluorescent ballasts, solid state relays or LED drivers. As well as selectable DC output, the eDIN De-multiplexer provides simple, elegant DMX control over dimmable LED ballasts. It also can provide single DMX-channel control over both the ballast and the mains power breaker in Mark 7-type dimmable fluorescent ballast systems, and the new rev4 board provides sinking control down to zero volts, along with a new panic contact closure input. The DIN form factor makes installation fast and easy within existing cabinets or buy a complete ETL-listed assembly.
Features:
- *NEW* Contact Closure “panic” input drives all outputs to full
- 16 analog outputs
- Selectable 0-10, 0-15, 0-2.5, & 0-5V output modes, or fully user-customized min/max
- Selectable current sink output
- 10mA current source per channel
- 20mA current sink per channel
- User-set DMX start address for easy daisy-chaining of modules
- RDM discoverable and configurable
- LED display and pushbuttons for configuration
- 2500V DMX input signal opto isolation
- 250V DMX fault protection
- End-of-line termination switch
- Status LEDs for power, DMX input
- Pluggable screw terminals for all connections
- DMX pass-thru connector
- Snap-on DIN rail housing
- DIN rail mounting section included
Specifications:
Output Rating |
10 VDC nominal, 16 VDC maximum 10mA current source per channel 20mA current sink per channel |
Power Supply |
9-30V DC, 5W supply required.Use eDIN 1001 power supply or equal |
Isolation | 2500V opto isolation 250V fault protection |
Size | 3.5″ x 6″ x 1.25″ (90mm x 152mm x 30mm ) |
Mounting | 35mm x 7.5mm DIN rail (included) |
Model Description:
1004 | eDIN 16 channel DMX-Analog Interface |
1001 | eDIN standard 30W power supply |